Vintage Twisted Ribbon Roses

Hello everyone, It's me, Craft Fairy with you again for another ribbon flower tutorial. This and lots more are avilable on my Craft Fairy Designs blog. I hope that you will come over and visit.


I've noticed that these twisted roses are appearing on many cards and sewing projects lately so I thought that I would bring you all a project and a video on how to do them. I've used fairly bright, well, very bright ribbon to make them as they can be shabby chic, but they can also be vivid and fashionable.

What You’ll Need:

Ribbon – at least 16mm wide

The one that I used here is the 23mm wide swiss dot grosgrain.

16mm satin ribbon in willow

a needle and thread

Cut a length of ribbon, about 30 to 45cm long. The longer (and wider) your ribbon, the larger your rose will be.
Tie a knot at one end of the ribbon, this will be the center of the rose.

Knot the end of the thread and secure it to the base of the knot.

Start twisting your ribbon and stitch it into place around the knot.

Carry on twisting the ribbon and sew it onto the rose that is developing.
Below is what it should look like from the front at this stage.
Keep on twisting and sewing until you have the size of rose that you want.

Once all the ribbon is wound up and secured, tuck the ends underneath and sew them into place with a few small stitchesKnot your thread, trim it, and you’re done
Now for the leaves. They are really simple too.

Take a length of the green satin ribbon and sew along one edge as shown. The longer the length the bigger the leaf. As a rule of thumb, your ribbon should be about two and a half times the width of the finished rose.
Pull the thread gently until you have gathered the ribbon as shown below.Stitch the ribbon together along the middle and then stitch it to the back of your rose and there you have it. Now you can make a card or far better brighten up a jumper or a hat.